Removal and Installation

Air Conditioning (A/C) Compressor - 2.0L GTDI Material Removal and Installation NOTICE: If installing a new Air Conditioning (A/C) compressor due to an internal failure of the old unit, either ...

Instrument Cluster and Panel Illumination

DESCRIPTION AND OPERATION Instrument Cluster and Panel Illumination Overview Dimmable Backlighting Dimmable illumination provides backlighting to certain switches and control components when the park ...

Other materials:

Specifications, Description and Operation
SPECIFICATIONS Material a 50/50 mixture coolant and distilled water.General Specifications Torque Specifications a Refer to the procedure. b Tighten to 5 Nm (44 lb-in) plus an additional 180 degrees. DESCRIPTION AND OPERATION Engine Cooling NOTICE: The engine cooling system ...

Headlamp exit delay
You can set the delay time to keep the headlamps on for up to three minutes after the ignition is turned off. Follow the steps below to change the delay time (Steps 1 through 6 must be done within 10 seconds): 1. Turn the ignition off. 2. Turn the lighting control to the autolamp position. ...

Diagnosis and Testing
Automatic Transmission Special Tool(s) Material DTC Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Diagnostic Methods in Section 100-00 for information about these practices. When the electrical connector ...