- Specifications, Description and Operation
- Diagnosis and Testing
- General Procedures
- Removal and Installation
Transaxle/Transmission Cooling - 6F35
SPECIFICATIONS
Material
Torque Specifications
DESCRIPTION AND OPERATION
Transaxle Cooling
The transmission fluid cooling system consists of the following:
OTA transmission fluid cooler
Front ...
Specifications, Description and Operation
SPECIFICATIONS
Torque Specifications
DESCRIPTION AND OPERATION
External Controls
The transmission selector lever linkage consists of:
a selector lever cable that connects the transmission manual ...
Other materials:
Starting a gasoline engine
When you start the engine, the idle speed increases, this helps to warm
up the engine. If the engine idle speed does not slow down automatically,
have your vehicle checked by an authorized dealer.
Note: You can crank the engine for a total of 60 seconds (without the
engine starting) before the ...
General Procedures
Accessing Mounting Bolts On an Inoperative Power Seat
General Equipment
Drill(s)
WARNING: Wear protective gloves when handling components or parts that
have pointed or sharp edges. Failure to follow this instruction may result in
serious personal injury.
NOTE: Typical driver seat shown, ot ...
Specifications, Description and Operation, General Procedures
SPECIFICATIONS
Material
General Specifications
Torque Specifications
a Tighten to 10 Nm (89 lb-in) plus an additional 720 degrees.
b Tighten to 16 Nm (142 lb-in) plus an additional 180 degrees.
c Refer to the procedure in this section.d Tighten to 5 Nm (44 lb-in) plus ...
